set protocols dot1x aaa radius nas-ip


The set protocols dot1x aaa radius nas-ip command configures the NAS IP address to the interface IP which connected to the RADIUS server.


Command Syntax

set protocols dot1x aaa radius nas-ip <ip-address>


Parameter

Parameter

Description

nas-ip <ip-address>

Specifies the NAS IP address to the interface IP which connected to the RADIUS server.


Usage Guidelines

This command is to set the nas-ip field in RADIUS access-request message. The value of the NAS IP address depends on the port connected to the RADIUS authentication server:

  • If you use the management interface eth0/eth1 to connect to the RADIUS server, the IP address of the management interface eth0/eth1 should be used for the NAS IP address configured here.
  • If you use the L3 VLAN interface, loopback interface, routed interface or sub-interface to connect to the RADIUS server, the IP address of the L3 VLAN interface, loopback interface, routed interface or sub-interface should be used for the NAS IP address configured here.


Example

  • Configure the NAS IP address to the interface IP which connected to the RADIUS server.
admin@Xorplus# set protocols dot1x aaa radius nas-ip 10.10.10.100
admin@Xorplus# commit

Copyright © 2024 Pica8 Inc. All Rights Reserved.