run show l3-interface tunnel
To display information about an GRE tunnel interface, use the run show l3-interface tunnel command in L2/L3 configuration mode.
NOTE:
GRE tunnel is a logical interface created by Linux kernel on software side. Once created, GRE tunnel stays in "UP" state in the display of this show command. Unless it is shut down by CLI command "set l3-interface tunnel ddd disable", the state will change to “DOWN”.
Command Syntax
run show l3-interface tunnel <tunnel-interface-name>
Parameters
Parameter | Description |
tunnel <tunnel-interface-name> | The GRE tunnel interface name. |
Example
- The following example displays information about GRE tunnel interface tnl1. In the output information, Inet addr indicates the tunnel interface IP address.
admin@Xorplus# run show l3-interface tunnel tnl1 tnl1 State:UP Tunnel Source: 1.1.1.1 Tunnel Destnation:: 2.2.2.2 Tunnel protocol/transport: gre-ip Inet addr: 10.1.1.1/24 Traffic statistics: 5 sec input rate IPv4 0 packets/sec, IPv6 0 packets/sec 5 sec forwarding rate IPv4 0 packets/sec, IPv6 0 packets/sec IPv4 Input Packets............................0 IPv4 Forwarding Packets.......................0 IPv6 Input Packets............................0 IPv6 Forwarding Packets.......................0
Copyright © 2024 Pica8 Inc. All Rights Reserved.