set protocols dot1x aaa radius nas-ip

The set protocols dot1x aaa radius nas-ip command configures the NAS IP address to the interface IP which connected to the RADIUS server.

Command Syntax

set protocols dot1x aaa radius nas-ip <ip-address>

Parameter

Usage Guidelines

This command is to set the nas-ip field in RADIUS access-request message. The value of the NAS IP address depends on the port connected to the RADIUS authentication server:

• If you use the management interface eth0/eth1 to connect to the RADIUS server, the IP address of the management interface eth0/eth1 should be used for the NAS IP address configured here.

• If you use the L3 VLAN interface, loopback interface, routed interface or sub-interface to connect to the RADIUS server, the IP address of the L3 VLAN interface, loopback interface, routed interface or sub-interface should be used for the NAS IP address configured here.

Example

• Configure the NAS IP address to the interface IP which connected to the RADIUS server.