run show l3-interface loopback


To display information about a L3 VLAN interface or loopback interface, use the run show l3-interface loopback command in L2/L3 configuration mode.

Command Syntax

run show l3-interface loopback {lo | <vrf-name>}

Parameters

ParameterDescription
{lo | <vrf-name>}

Required parameter. Specifies VRF name. 

  • lo: indicates the loopback interface in default VRF.
  • <vrf-name>: Specifies VRF name. The value is a string.

Example

  • The following example displays information about the loopback interface in the default VRF:
admin@Switch# run show l3-interface loopback lo 
lo          Hwaddr E0:07:1B:C9:20:9B, Vlan:4095, MTU: 1500, State:UP 
            Inet addr: fe80::e207:1b20:c9:209b/64
            Traffic statistics:
              5 sec input rate IPv4 0 packets/sec, IPv6 0 packets/sec
              5 sec forwarding rate IPv4 0 packets/sec, IPv6 0 packets/sec
              IPv4 Input Packets............................0
              IPv4 Forwarding Packets.......................0
              IPv6 Input Packets............................0
              IPv6 Forwarding Packets.......................0


Copyright © 2024 Pica8 Inc. All Rights Reserved.