Configure Port Speed of eth0 Out-of-Band Management Interface

The management interface eth0 is a special Ethernet interface that provides configuration management support for the user, that is, the user can log on to the device and perform configuration and management operations through this interface. The eth0 management interface is not responsible for the transmission of data services.

The following command can be used to configure the port speed (in Mbit/s) of eth0 out-of-band management interface in operational mode.

set management-ethernet-speed eth0 <10 | 100 | 1000 | auto>

Example

Configure port speed of eth0 out-of-band management interface to 100Mbit/s and show the configuration result.

admin@PICOS> set management-ethernet-speed eth0 100
admin@PICOS> start shell sh
admin@PICOS:~$ sudo ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supported pause frame use: Symmetric
        Supports auto-negotiation: Yes
        Supported FEC modes: Not reported
        Advertised link modes:  Not reported
        Advertised pause frame use: Symmetric
        Advertised auto-negotiation: No
        Advertised FEC modes: Not reported
        Speed: 100Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 2
        Transceiver: internal
        Auto-negotiation: off
        MDI-X: Unknown