set management-ethernet-speed eth0

The set management-ethernet-speed eth0 command configures port speed of eth0 out-of-band management interface in operational mode.

 

Command Syntax

set management-ethernet-speed eth0 <10 | 100 | 1000 | auto>

 

Parameter

Null.

Example

  • Configure port speed of eth0 out-of-band management interface to 100Mbit/s and show the configuration result.

admin@PICOS> set management-ethernet-speed eth0 100 admin@PICOS> start shell sh admin@PICOS:~$ sudo ethtool eth0 Settings for eth0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: Symmetric Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: Not reported Advertised pause frame use: Symmetric Advertised auto-negotiation: No Advertised FEC modes: Not reported Speed: 100Mb/s Duplex: Full Port: Twisted Pair PHYAD: 2 Transceiver: internal Auto-negotiation: off MDI-X: Unknown

Copyright © 2024 Pica8 Inc. All Rights Reserved.