set system inband loopback

Owned by Tracy Yang
May 24, 2024
1 min read

The set system inband loopback command sets the loopback interface IP in the default VRF as the inband management IP.


Command Syntax

set system inband loopback <ip-address>


Parameter

Parameter

Description

loopback <ip-address>

Specifies the loopback interface IP in the default VRF as the inband management IP. The value could be an IPv4 or IPv6 address.


Example

  •   Enable the inband management function of the loopback interface.
admin@Xorplus# set system inband loopback 192.168.100.1
admin@Xorplus# commit

Copyright © 2024 Pica8 Inc. All Rights Reserved.