erps switch force ring instance

The erps switch force ring instance command configures to block a specific ring instance in the way of force switch in CLI operational mode.

 

Command Syntax

erps switch force ring <ring-id> instance <instance-id> <port0 | port1>

 

Parameter

Parameter

Description

ring <ring-id>

Specifies the ID of the ring. The value is an integer that ranges from 1 to 8.

instance <instance-id>

Specifies the instance ID for a ring. The value is an integer that ranges from 1 to 2.

Usage Guidelines

When configuring this command, pay attention to the following notes:

The command erps switch force ring <ring-id> instance <instance-id> <port0 | port1> is an operational mode command which should be executed under the prompt “admin@PICOS>”.

ERPS supports two switching methods to manually configure port blocking:

  • Forced switch: Ports configured for forced switch are blocked immediately, regardless of whether other links on the ring are faulty or not.

  • Manual switch: Ports configured for manual switch are blocked if the state of the ring is Idle or Pending, otherwise they are not blocked.

The run show erps ring command can be used to show the node state of the ERPS ring instances. If force switch (or manual switch) is set successfully, the Node state in the show result displays Forced Switch (or Manual Switch).

The erps clear ring instance command can be used to clear the blocking point switching operation of the ERPS ring.

 

Example

  • Configure to block a specific ring instance in the way of force switch.

admin@PICOS> erps switch force ring 5 instance 2 port0

Copyright © 2024 Pica8 Inc. All Rights Reserved.