run show ethernet-oam
The run show ethernet-oam command is used to view EFM OAM information and session status.
Â
Command Syntax
run show ethernet-oam [interface <interface-name>]
Â
Parameter
Parameter | Description |
interface <interface-name> | Optional. Specifies an interface name that enabled EFM OAM. The value is a physical interface. If not specified, EFM OAM information and session status of all the interfaces enabled EFM OAM will be displayed. |
Â
Example
View EFM OAM information and session status.
admin@PICOS# run show ethernet-oam interface ge-1/1/1
--------------------------------------------------
Interface ge-1/1/1
Local client
Admin state: enable
OAM Mode: passive
OAM timeout: 30 seconds
Loopback timeout: 3 seconds
Loopback status: local loopback
PDU revision: 3
OAM status: SEND_ANY
PDU: ANY
Remote client
MAC address: 18:5a:58:5c:8c:21
OUI: 48:6e:73
PDU revision: 3
OAM Mode: active
Unidirection: not supported
Link monitor: not supported
Remote loopback: not supported
MIB retrieval: not supported
Mtu size: 1500
The following table provides the description of the EFM OAM status information in the run show ethernet-oam command output.
Item | Description |
Admin state | Whether the OAM function of an interface is enabled. |
Loopback status | Indicates the status of remote loopback. The value could be no loopback, remote loopback or local loopback.
|
OAM status | Indicates the OAM status of an interface. The values are as follows:
|
PDU | The way in which the local end processes Ethernet OAMPDUs:
|
Copyright © 2024 Pica8 Inc. All Rights Reserved.