set vlans dot1q-tunneling ingress then
To configure tunneling for ingress traffic received at a port and adding customer or service tag to frames, use the set vlans dot1q-tunneling ingress then command in L2/L3 configuration mode.
Command Syntax
set vlans dot1q-tunneling ingress tunnel-id then { customer-vlan | service-vlan } vlan-id
Parameters
tunnel-id | Tunnel identifier. |
customer-vlan | The new customer VLAN identifier. |
service-vlan | The new service VLAN identifier. |
vlan-id | VLAN identifier. The range is 0-4094. |
Examples
The following example configures the T0 tunneling to add customer tag 10 and service tag 100 to frames:
admin@Switch# set vlans dot1q-tunneling ingress T0 then customer-vlan 10
admin@Switch# set vlans dot1q-tunneling ingress T0 then service-vlan 100