/
protocols rip interface vif address authentication md5 start-time

protocols rip interface vif address authentication md5 start-time

Owned by Tracy Yang (Unlicensed)
Dec 05, 2019

To configure the start time (and date) for MD5 authentication of RIP packets, use the set protocols rip interface vif address authentication md5 start-time command in L2/L3 configuration mode.

Command Syntax

set protocols rip interface interface-name vif vif-name address ip-address authentication md5 key-id start-time time

Parameters

interface-nameInterface name.
vif-nameVirtual interface name.
ip-addressVirtual interface IP address for RIP.
key-idMD5 authentication key identifier. The range is 0-255.
timeAuthentication start time (and date). The format to be used is YYYY-MM-DD.HH:MM.

Example

This example configures the start time (and date) for MD5 authentication of RIP packets:

admin@Switch# set protocols rip interface vlan10 vif vlan10 address 10.1.1.1 authentication md5 1 start-time 2014-3-31.21:21

Related content

Copyright © 2025 Pica8 Inc. All Rights Reserved.