set protocols vrrp interface vif vrid

The set protocols vrrp interface vif vrid command creates a VRRP group.

NOTE:

This command applies to both VRRPv2 and VRRPv3 configuration.

Command Syntax

set protocols vrrp interface <interface-name> vif <vif-name> vrid <virtual-router-id>

Parameter

Parameter	Description
interface <interface-name>	Specifies the Layer 3 interface name of VRRP device. The value is a string.
vif <vif-name>	Specifies the VLAN interface name. The value is a string.
vrid <virtual-router-id>	Specifies the VRID of a VRRP group. The value is an integer that ranges from 1 to 254.

Usage Guidelines

When configuring VRID, pay attention to the following points:

A VRID identifies the devices of the same VRRP group. Two devices in a VRRP group must be configured with the same VRID.

It is recommended that VRRP groups on different VLAN interfaces of a device should be configured with different VRIDs.

One chassis switch supports a maximum of 128 VRRP groups. Please set the number of VRRP group based on device performance.

Example

admin@Xorplus# set protocols vrrp interface vlan100 vif vlan100 vrid 2
admin@Xorplus# commit

PICOS-3.8_Configuration_Guide