set firewall filter copp sequence from source-address-ipv4

The set firewall filter copp sequence from source-address-ipv4 command configures a firewall filter rule based on the source IPv4 address for traffic classification.

Command Syntax

set firewall filter copp sequence <number> from source-address-ipv4 <ipv4-address>

Parameter

Parameter

Description

sequence <number>

Specifies filter sequence number. The value is an integer that ranges from 0 to 9999.

The 18 integers 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180 are not allowed to be used for sequence numbers in user-defined CoPP firewall filter rules.

source-address-ipv4 <ipv4-address>

Specifies source IP, it could be a specific IPv4 address or an IPv4 subnet. For example, 192.168.1.10, 10.1.1.0/24.

Usage Guidelines

You can run the set firewall filter copp sequence from source-address-ipv4 command to configure a firewall filter rule based on the source IPv4 address for traffic classification so that the device processes packets matching the same firewall filter rule in the same manner.

Example

• Configure a firewall filter rule based on the source IPv4 address of 10.1.1.0/24.

admin@XorPlus# set firewall filter copp sequence 51 from source-address-ipv4 10.1.1.0/24
admin@XorPlus# commit