set system syslog server-ip
- Tracy Yang (Unlicensed)
The set system syslog server-ip command configures the remote syslog server on the switch, including IP address, port number, transmission protocol and source interface. After user configures the syslog server IP address, the log files will be sent to the syslog server.
The delete system syslog server-ip command deletes the configuration of remote syslog server.
Command Syntax
set system syslog server-ip <ip_address> [ port <port_number> | protocol <tcp | udp> | source-interface <source-interface>]
Parameter
Parameter | Description |
server-ip <ip_address> | Specifies IP address of a remote syslog server. It could be an IPv4 address or IPv6 address. |
| port <port_number> | Optional. Specifies the port of the remote syslog server. The value is an integer type. |
| protocol <tcp | udp> | Optional. Specifies the transmission protocol for the remote syslog server. The value could be tcp or udp. |
| source-interface <source-interface> | Optional. Specifies the source interface for sending/receiving syslog messages, e.g. vlan20, eth0, routed interface, sub-interface or loopback. |
Notes:
- The IP address of the source interface will be used as the source IP in the IP header after syslog message is routed.
- If syslog uses TCP protocol, source-interface can't be configured at the same time.
Example
• This example configures how to set the IP address of the remote syslog server.
admin@XorPlus# set system syslog server-ip 192.168.1.1 admin@XorPlus# commit
Copyright © 2024 Pica8 Inc. All Rights Reserved.