set interface gigabit-ethernet rate-limiting ingress burst

The set interface gigabit-ethernet rate-limiting ingress burst command sets a burst limit value on a port for the ingress traffic.

NOTE:

Tomahawk series switches (including Tomahawk, Tomahawk+, Tomahawk2 and so forth) do not support ingress interface-based rate limiting.

Command Syntax

set interface gigabit-ethernet <interface-name> rate-limiting ingress burst <burst-size>

Parameter

Parameter

Description

interface <interface-name>

Specifies an interface name. The value is a string.

burst <burst-size>

Specifies the burst size in kbit, which is the maximum volume of burst traffic that can pass through an interface. The value is an integer from 1 to the value of interface rate.

When burst size is not configured, PICOS uses a burst size adapted according to the configured rate limiting value configured by the set interface gigabit-ethernet <interface-name> rate-limiting ingress kilobits <value> or set interface gigabit-ethernet <interface-name> rate-limiting ingress ratio <value> command.

Example

Set the burst size value to 10 kbit on port ge-1/1/1 for the ingress traffic.

admin@Xorplus# set interface gigabit-ethernet ge-1/1/1 rate-limiting ingress burst 10
admin@Xorplus# commit