PICOS Routing and Switching Configuration Guide

Pica8 PicOS supports Layer 2 switching protocols, including: STP, RSTP, MSTP, MAC learning, and Q-in-Q. PicOS also supports several Layer 3 protocols, including: static routing, RIPv2, OSPF, IGMP, PIM-SM, and IPv6. This guide provides instructions and examples for configuring switches and controllers. Intended for system administrators, this guide assumes a working knowledge of Layer 2 and Layer 3 protocols.


PicOS can run in 2 different modes of operation:

  •  Open vSwitch (OVS) Mode: In this mode, PicOS is dedicated and optimized for OpenFlow applications.
  •  Layer 2/Layer 3 (L2/L3) Mode: In this mode, PicOS can run switching and routing protocols, as well as OpenFlow applications.

In OVS mode, L2/L3 daemons are not running, and the system is fully dedicated to OpenFlow and OVS. In L2/L3 mode, L2/L3 daemons are running, and OVS can also be used if OpenFlow in Crossflow Mode is activated.

This chapter assumes that user is running PicOS L2/L3 mode. Please see PICOS Mode Selection to learn how to switch between L2/L3 and OVS modes.


Supported Features

Collection of Feature Specification of Different Platforms

Command-Line Interface

System Administration

Interface Management Configuration Guide

Layer 2 Switching Configuration

Layer 3 Routing Configuration

IP Multicast Routing Configuration

ACL Configuration

QoS Configuration

VXLAN Configuration

BGP EVPN Configuration Guide

Generic Routing Encapsulation Protocol (GRE)

OpenFlow in Crossflow Mode



Copyright © 2024 Pica8 Inc. All Rights Reserved.