QoS Configuration Commands
This section contains descriptions of the Layer2 and Layer3 QoS configuration commands that this chapter references.
- class-of-service classifier <classifier-name>
- class-of-service classifier <classifier-name> forwarding-class <forwarding-class-name> code-point <code-point>
- class-of-service classifier <classifier-name> trust-mode <trust-mode>
- class-of-service forwarding-class <forwarding-class-name> local-priority <local-priority>
- class-of-service interface <port> classifier <classifier-name>
- class-of-service scheduler <scheduler-name> guaranteed-rate <guaranteed-rate>
- class-of-service scheduler <scheduler-name> mode SP
- class-of-service scheduler <scheduler-name> mode WFQ
- class-of-service scheduler <scheduler-name> mode WRR
- class-of-service scheduler <scheduler-name> weight <weight-id>
- class-of-service scheduler-profile <scheduler-profile-name> forwarding-class <forwarding-class-name> schedule <schedule-name>
- show class-of-service <text>
- set class-of-service interface scheduler-profile
- class-of-service interface <port> default-priority <default-priority-type> <default-priority-int>
- class-of-service pfc-profile <profile-name> code-point <code-point> drop <boolean>
- class-of-service interface <port> pfc-profile <profile-name>
- set firewall filter sequence then dscp
- set class-of-service scheduler max-rate
- CoPP Commands
- set class-of-service forwarding-class local-priority
- set class-of-service scheduler max-bandwidth-pps
- set class-of-service scheduler min-bandwidth-pps
- set class-of-service scheduler-profile copp-profile forwarding-classs scheduler
- set class-of-service scheduler weight
- set firewall filter copp sequence from destination-address-ipv4
- set firewall filter copp sequence from destination-address-ipv6
- set firewall filter copp sequence from destination-mac-address
- set firewall filter copp sequence from destination-port
- set firewall filter copp sequence from ether-type
- set firewall filter copp sequence from protocol
- set firewall filter copp sequence from source-address-ipv4
- set firewall filter copp sequence from source-address-ipv6
- set firewall filter copp sequence from source-mac-address
- set firewall filter copp sequence from source-port
- set firewall filter copp sequence from vlan
- set firewall filter copp sequence then forwarding-class
- set firewall filter copp sequence then dscp
- run show copp bandwidth
- run show copp statistics
- run show filter copp
- run show interface stm
- run clear copp statistics
- Buffer Management Commands
- Interface-based Rate Limiting Commands
- set interface gigabit-ethernet rate-limiting ingress kilobits
- set interface gigabit-ethernet rate-limiting ingress ratio
- set interface gigabit-ethernet rate-limiting ingress burst
- set interface gigabit-ethernet rate-limiting egress kilobits
- set interface gigabit-ethernet rate-limiting egress ratio
- set interface gigabit-ethernet rate-limiting egress burst
- ACL-based Traffic Policer Commands
Copyright © 2024 Pica8 Inc. All Rights Reserved.