run show interface stm

Owned by Tracy Yang (Unlicensed)
Apr 26, 2023
1 min read

The run show interface stm command displays the total STM resources that are available and how many STM entries are in use. 

Note:

It is allowed to configure the firewall filter rule only when there are available STM resources.


Command Syntax

run show interface stm


Parameter

None.


Example

• Show the information of STM resources.   

admin@Xorplus# run show interface stm
Total stm resource:
  Share-mode: 5
  number of host routes: 32768
  number of mac unicast addresses: 32768 
  number of firewall ingress tables: 896
  number of firewall egress tables: 510
  number of IPv4 unicast routes: 5000
  number of IPv6 unicast routes: 500
Stm resource in use:
  number of firewall ingress tables: 2
  number of firewall egress tables: 29

The item number of firewall egress tables is used for describing STM resources of CoPP. By default, the value of number of firewall egress tables in Stm resource in use: is 21 as have been used by the default CoPP configurations.

Copyright © 2024 Pica8 Inc. All Rights Reserved.