set poe interface mode

This command is applied on AS4610-30P, AS4610-54P, AS4630-54PE and AS4630-54NPE.

The  set poe interface mode command configures PoE pair mode on all the ports or a specific physical port.


Command Sytax

set poe interface {<port-id> | allmode <value>


Parameter

ParameterDescription

interface {<port-id> | all}

Specifies interface ID. The value could be ge-1/1/1 to ge-1/1/48, all indicates a global configuration that set a same mode on all ports.

mode <value>

Specifies PoE pair mode, the value can be signal and spare.

  • signal: Pair type A, deliver power with data transmit wires.
  • spare: Pair type B, deliver power with spare wires.

The default value is signal.

Note:

Configuration on a specific port has a higher priority than that of global configuration. 


Example

This example is to configure pair mode spare on all the ports and ge-1/1/1:

admin@XorPlus# set poe interface all mode spare
admin@XorPlus# commit
  
admin@XorPlus# set poe interface ge-1/1/1 mode spare
admin@XorPlus# commit

Copyright © 2024 Pica8 Inc. All Rights Reserved.