set interface gigabit-ethernet ptp mode
The set interface gigabit-ethernet ptp mode command configures the device interface as the E2ETC node type, and enables the PTP function on the interface.
Command Syntax
set interface gigabit-ethernet <port> ptp mode {e2etransparent | none}
Parameter
Parameter | Description |
---|---|
port | Ethernet switching port identifier, the valid ports range: 1-52. |
ptp mode {e2etransparent | none} | Configure the PTP mode on a switch interface: • e2etransparent: configures the device interface as the E2ETC node type  and enables the PTP function on the interface. • none: disable the PTP function on the interface. |
Note: the PTP function can only be configured on the physical interface.
Â
Example
• Configure the port te-1/1/25 that receiving PTP messages and the port te-1/1/26 that sends PTP packets as E2ETC node.
admin@Xorplus# set interface gigabit-ethernet te-1/1/25 ptp mode e2etransparent admin@Xorplus# set interface gigabit-ethernet te-1/1/26 ptp mode e2etransparent
Copyright © 2024 Pica8 Inc. All Rights Reserved.