set protocols dhcp relay interface dhcp-server-address

Owned by Tracy Yang
Nov 13, 2023
1 min read

The set protocols dhcp relay interface dhcp-server-address command configures a DHCP server address on the L3 interface enabled with DHCP relay.


Command Syntax

set protocols dhcp relay interface <l3-interface-name> dhcp-server-address <server-ipv4-address>


Parameters

Parameter

Description

interface <l3-interface-name>

Specifies an L3 interface name. The value could be the VLAN interface name, the loopback interface name, the routed interface or the sub-interface name.

dhcp-server-address <server-ipv4-address>

Specifies the IPv4 address of a DHCP server. The value is in dotted decimal notation.


Usage Guidelines

You can repeat this command to configure multiple DHCP servers.

NOTE: The DHCP server IP address should not be in the same subnet with the L3 interface enabled with the DHCP relay.


Example

  • Configure DHCP relay and DHCP server address on L3 VLAN interface vlan100.
admin@Xorplus# set protocols dhcp relay interface vlan100 dhcp-server-address 10.10.1.1

Copyright © 2024 Pica8 Inc. All Rights Reserved.