/
run show interface diagnostics tdr
run show interface diagnostics tdr
The run show interface diagnostics tdr command.
Command Syntax
run show interface diagnostics tdr <interface-name>
Parameter
Parameter | Description |
tdr <interface-name> | Specifies interface name of Ethernet electrical interface. |
Example
- Run the following command to start the TDR cable test. The following example shows the cable length (Pair length) is approximately 31 meters long with a possible error of +/- 10 meters. All four pairs are working fine (Pair status).
admin@Xorplus# run show interface diagnostics tdr ge-1/1/1 Interface Local pair Pair length(meter) Remote pair Pair status ---------- ---------- ------------------ ----------- ----------- ge-1/1/1 Pair A 31 +/- 10 Pair A OK Pair B 31 +/- 10 Pair B OK Pair C 31 +/- 10 Pair C OK Pair D 30 +/- 10 Pair D OK
Table 2. Description of the run show interface diagnostics tdr output
Item | Description |
Interface | Indicates the name of the interface on which TDR test is enabled. |
Local pair | Local four pairs. |
Pair length(meter) | Displays the length and error of the cable pair in meters.
|
Remote pair | Remote four pairs. |
Pair status | The pair status could be "OK", "OPEN", "SHORT", "OPENSHORT", "CROSSTALK" or "N/A".
|
, multiple selections available,
Related content
run show interface diagnostics tdr
run show interface diagnostics tdr
More like this
run show interface diagnostics tdr
run show interface diagnostics tdr
More like this
run show interface diagnostics tdr
run show interface diagnostics tdr
More like this
run show interface diagnostics tdr
run show interface diagnostics tdr
More like this
run show interface diagnostics tdr
run show interface diagnostics tdr
More like this
run show interface diagnostics tdr
run show interface diagnostics tdr
More like this
Copyright © 2025 Pica8 Inc. All Rights Reserved.