set interface gigabit-ethernet auto-speeds

The set interface gigabit-ethernet auto-speeds command sets the auto-negotiation rate of an interface in auto-negotiation mode.

Command Syntax

set interface gigabit-ethernet <interface-name> auto-speeds <auto-speed>

Parameter

Usage Guidelines

Run the set interface gigabit-ethernet<interface-name> speed auto command to configure the Ethernet interface to work in auto-negotiation mode before using the set interface gigabit-ethernet <interface-name> auto-speeds command to manually specify the auto-negotiation rate.

Only the 10G, 5G/2.5G and 1G RJ45 ports support auto-negotiation mode. By default, these interfaces work in auto-negotiation mode. In auto-negotiation mode the ports negotiate any rate supported by the two devices. If the negotiated interface rate is not the required value, you can use the set interface gigabit-ethernet <interface-name> auto-speeds command to manually specify the auto-negotiation rate to make the interface negotiate the rate within the specified range.

Example

•    Set the auto-negotiation rates of ge-1/1/1 interface to 100M and 10M.

admin@Xorplus# set interface gigabit-ethernet ge-1/1/1 auto-speeds 100
admin@Xorplus# set interface gigabit-ethernet ge-1/1/1 auto-speeds 10
admin@Xorplus# set interface gigabit-ethernet ge-1/1/1 speed auto

•   Set the auto-negotiation rates of ge-1/1/1 interface to 1000M.

admin@Xorplus# set interface gigabit-ethernet ge-1/1/1 auto-speeds 1000
admin@Xorplus# set interface gigabit-ethernet ge-1/1/1 speed auto