/
set protocols ospf6 interface area
set protocols ospf6 interface area
Run the command set protocols ospf6 interface area to enable OSPFv3 on a specific interface and map that interface to an area.
Run the command delete protocols ospf6 interface to remove this configuration.
Command Syntax
set protocols ospf6 interface <interface-name> area <ipv4>
delete protocols ospf6 interface <interface-name> area <ipv4>
Parameters
Parameter | Description |
area <ipv4> | Specifies the area for OSPFv3, the value is in IPv4 dotted decimal format. |
interface <interface-name> | Specifies the VLAN interface name, the loopback interface name, the routed interface or the sub-interface name. |
Usage Guidelines
You can add the L3 interface to a specified VRF to specify the VRF for the OSPFv3 instance. If L3 VLAN interface/loopback interface is not added to a specified VRF, then the command takes effect in the default VRF.
The following commands add the L3 VLAN interface to a specified VRF and specify the VRF for the OSPFv3 instance.
admin@XorPlus# set l3-interface vlan-interface vlan100 vrf "vrf1" admin@XorPlus# set protocols ospf6 interface vlan100 area 0.0.0.0
Example
- This example enable OSPFv3 on L3 VLAN interface vlan100 and bind the interface to area 0.0.0.0.
admin@XorPlus# set protocols ospf6 interface vlan100 area 0.0.0.0
, multiple selections available,
Related content
set protocols ospf6 interface area
set protocols ospf6 interface area
More like this
set protocols ospf6 interface area
set protocols ospf6 interface area
More like this
set protocols ospf6 interface area
set protocols ospf6 interface area
More like this
set protocols ospf6 interface area
set protocols ospf6 interface area
More like this
set protocols ospf6 interface area
set protocols ospf6 interface area
More like this
set protocols ospf6 interface area
set protocols ospf6 interface area
More like this
Copyright © 2025 Pica8 Inc. All Rights Reserved.