protocols ospf4 area interface vif address disable

To enable or disable OSPF for an address, use the set protocols ospf4 area interface vif address disable command in L2/L3 configuration mode.

Command Syntax

set protocols ospf4 area area-id interface interface-name vif vif-name address ip-address disable { true | false }

Parameters

area-id	OSPF area identifier. Use dotted decimal notation. For example, use 0.0.0.0 for area 0.
interface-name	Interface name.
vif-name	Virtual interface name.
ip-address	Virtual interface IP address used for OSPF.
true	Disable OSPF on the interface.
false	Do not disable OSPF on the virtual interface.

Example

The following example disables OSPF on a virtual interface IP address:

admin@Switch# set protocols ospf4 area 0.0.0.0 interface vlan2 vif vlan2 address 10.2.2.1 disable true