set protocols bfd peer echo receive-interval

The set protocols bfd peer echo receive-interval command configures the minimum time interval between received BFD echo packets for a single-hop BFD session.

The delete protocols bfd peer echo receive-interval command sets the configuration to the default value.

Command Syntax

set protocols bfd [vrf <vrf-name>] [interface<interface-name>] peer<peer-ip> echo receive-interval [<receive-interval> | disabled]

Parameter

Parameter	Description
vrf <vrf-name>	Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>].
interface<interface-name>	Optional. Specifies the egress interface for BFD packets. The value is an L3 interface that can be the VLAN interface name, the loopback interface name, the routed interface or the sub-interface name. The value is a string. If not specified, the system will search the route table for the outgoing interface.
peer <peer-ip>	Specifies the peer for a BFD session. The value is an IPv4 or IPv6 address.
echo receive-interva [<receive-interval> \| disabled]	Specifies the minimum time interval between received BFD echo packets in milliseconds. The value disabled indicates that the switch does not support reception of BFD echo packets. Range: 10 to 60000. Default: 50ms.

Example

Configure the minimum time interval between received BFD echo packets to 60 milliseconds.

admin@Xorplus# set protocols bfd peer 2.2.2.2 echo receive-interval 60
admin@Xorplus# commit