run show l3-interface vlan-interface

To display information about an L3 VLAN interface, use the run show l3-interface vlan-interface command in L2/L3 configuration mode.

Command Syntax

run show l3-interface vlan-interface <interface-name> [detail]

Parameters

Parameter	Description
interface-name	Optional. The VLAN interface name.
detail	Optional. Show detail informations of all VLAN interface.

Example

The following example displays information about vlan10:

admin@Switch# run show l3-interface vlan-interface vlan10 
vlan10      Hwaddr E0:07:1B:C9:20:9B, Vlan:10, MTU: 1450, State:UP 
            Inet addr: 10.1.1.166/24
                       fe80::e207:1b20:1c9:209b/64
            Traffic statistics:
              5 sec input rate IPv4 0 packets/sec, IPv6 0 packets/sec
              5 sec forwarding rate IPv4 0 packets/sec, IPv6 0 packets/sec
              IPv4 Input Packets............................0
              IPv4 Forwarding Packets.......................0
              IPv6 Input Packets............................0
              IPv6 Forwarding Packets.......................0

The following example displays the detail information about vlan10:

admin@Switch# run show l3-interface vlan-interface vlan10 detail
vlan10      Hwaddr E0:07:1B:C9:20:9B, Vlan:10, MTU: 1450, State:UP 
            Inet addr: 10.1.1.166/24
                       fe80::e207:1b20:1c9:209b/64
            Traffic statistics:
              5 sec input rate IPv4 0 packets/sec, IPv6 0 packets/sec
              5 sec forwarding rate IPv4 0 packets/sec, IPv6 0 packets/sec
              IPv4 Input Packets............................0
              IPv4 Forwarding Packets.......................0
              IPv6 Input Packets............................0
              IPv6 Forwarding Packets.......................0
            Port        State         Tag
            ----------  ------------  --------
            te-1/1/1    FORWARDING    tagged
            te-1/1/17   DOWN          tagged
            te-1/1/2    FORWARDING    tagged