set protocols bfd peer detect-multiplier



The set protocols bfd peer detect-multiplier command configures the detection multiplier to determine packet loss for a single-hop BFD session.

The delete protocols bfd peer detect-multiplier command sets the configuration to the default value.


Command Syntax

set protocols bfd  [vrf <vrf-name>] [interface<interface-name>] peer<peer-ip> detect-multiplier <MULTIPLIER>


Parameter

Parameter

Description

vrf <vrf-name>

Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>].

interface<interface-name>

Optional. Specifies the egress interface for BFD packets. The value is an  L3 interface that can be the VLAN interface name, the loopback interface name, the routed interface or the sub-interface name. The value is a string.

If not specified, the system will search the route table for the outgoing interface.

peer <peer-ip>Specifies the peer for a BFD session. The value is an IPv4 or IPv6 address.

detect-multiplier <MULTIPLIER>

Specifies the BFD detection multiplier. The value is an integer that ranges from 2 to 255. The default value is 3.


Usage Guidelines

The remote transmission interval will be multiplied by this value to determine the connection loss detection timer.

Example: when the local system has detect-multiplier 3 and the remote system has transmission interval 300, the local system will detect failures only after 900 milliseconds without receiving packets.


Example

  • Configure the BFD detection multiplier to 4 for BFD peer 2.2.2.2.
admin@Xorplus# set protocols bfd peer 2.2.2.2 detect-multiplier 4
admin@Xorplus# commit

Copyright © 2024 Pica8 Inc. All Rights Reserved.