set protocols bfd peer transmit-interval
- Tracy Yang
Analytics
The set protocols bfd peer transmit-interval command configures the minimum transmission interval (less jitter) that this system wants to use to send BFD control packets for a single-hop BFD session.
The delete protocols bfd peer transmit-interval command sets the configuration to the default value.
Command Syntax
set protocols bfd [vrf <vrf-name>] [interface<interface-name>] peer<peer-ip> transmit-interval <transmit-interval>
Parameter
Parameter | Description |
vrf <vrf-name> | Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. |
interface<interface-name> | Optional. Specifies the egress interface for BFD packets. The value is an L3 interface that can be the VLAN interface name, the loopback interface name, the routed interface or the sub-interface name. The value is a string. If not specified, the system will search the route table for the outgoing interface. |
| peer <peer-ip> | Specifies the peer for a BFD session. The value is an IPv4 or IPv6 address. |
transmit-interval <transmit-interval> | Specifies the minimum transmission interval in milliseconds. Range: 300 to 60000. Default: 300ms. |
Example
- Configure the minimum transmission interval to 500 milliseconds.
admin@Xorplus# set protocols bfd peer 2.2.2.2 transmit-interval 500 admin@Xorplus# commit
Related content
Copyright © 2025 Pica8 Inc. All Rights Reserved.