/
protocols rip interface vif address update-jitter
protocols rip interface vif address update-jitter
- Tracy Yang (Unlicensed)
Owned by Tracy Yang (Unlicensed)
Mar 16, 2021
Loading data...
To configure jitter for regular RIP update interval, use the set protocols rip interface vif address update-jitter in L2/L3 configuration mode.
Command Syntax
set protocols rip interface interface-name vif vif-name adress ip-address update-jitter percent
Parameters
| interface-name | Interface name. |
| vif-name | Virtual interface name. |
| ip-address | Virtual interface IP address used for RIP. |
| percent | Jitter as a percentage of RIP update-interval. The range is 0-100. |
Example
The following example configures jitter as 10 percent of the RIP update-interval:
admin@Switch# set protocols rip interface vlan10 vif vlan10 address 10.1.1.1 update-jitter 10
Copyright © 2025 Pica8 Inc. All Rights Reserved.