set protocols ospf6 area interface vif priority

To configure the priority of an OSPFv3 interface for DR election, use the protocols ospf6 area interface vif priority command in L2/L3 configuration mode.

Command Syntax

set protocols ospf6 vrf vrf-name area area-id interface interface-name vif vif-name priority level

Parameters

vrf-name	Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. Note that: The configuration is in the default VRF if not explicitly bound to any VRF.
area-id	OSPFv3 area identifier. Use the dotted decimal notation. For example, 0.0.0.0 for area 0.
interface-name	Interface name.
vif-name	Virtual interface name.
level	The priority used in OSPFv3 DR (designated router) election. The range is 0-255. The 0 priority means the interface cannot become DR.

Example

The following example set the priority of OSPFv3 interface vlan2 as 8:

admin@Switch# set protocols ospf6 area 0.0.0.0 interface vlan2 vif vlan2 priority 8