set protocols ospf6 area interface vif transmit-delay

To set the estimated time needed to send an OSPFv3 LSA update packet, use the set protocols ospf6 area interface vif transmit-delay command in L2/L3 configuration mode.

Command Syntax

set protocols ospf6 vrf vrf-name area area-id interface interface-name vif vif-name transmit-delay time

Parameters

vrf-name	Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. Note that: The configuration is in the default VRF if not explicitly bound to any VRF.
area-id	OSPFv3 area identifier.
interface-name	Interface name.
vif-name	Virtual interface name.
time	The estimated time to send and LSA to a neighbor. The range is 0-3600.

Example

The following example configures OSPFv3 transmit delay to 2 seconds:

admin@Switch# set protocols ospf6 area 0.0.0.0 interface vlan2 vif vlan2 transmit-delay 2