set protocols ospf6 area interface vif address disable

To enable OSPFv3 on an IP address, use the set protocols ospf6 area interface vif address disable command in L2/L3 configuration mode.

Command Syntax

set protocols ospf6 vrf vrf-name area area-id interface interface-name vif vif-name address ip-address disable { true | false }

Parameters

vrf-name	Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. Note that: The configuration is in the default VRF if not explicitly bound to any VRF.
area-id	OSPFv3 area identifier for the area to which the attached network belongs.
interface-name	Interface name.
vif-name	Virtual interface name.
ip-address	Virtual interface IPv6 address.
true	Disable OSPFv6.
false	Enable OSPFv6.

Example

The following example configures OSPF for an IPv6 address.

admin@Switch# set protocols ospf6 area 0.0.0.0 interface vlan1 vif vlan1 address 2001::1 disable false