protocols rip interface vif address triggered-jitter

To configure the jitter of repeated triggered update, use the set protocols rip interface vif address triggered-jitter command in L2/L3 configuration mode.

Command Syntax

set protocols rip interface interface-name vif vif-name address ip-address triggered-jitter percent

Parameters

interface-name	Interface name.
vif-name	Virtual interface name.
ip-address	Virtual interface IP address used for RIP.
percent	Jitter as a percentage of triggered-delay. The range is 0-100.

Example

The following example configures jitter for repeated triggered update delay as 10 percent of the triggered-delay:

admin@Switch# set protocols rip interface vlan10 vif vlan10 address 10.1.1.1 triggered-jitter 10