set protocols static route next-hop

The set protocols static route command configures a unicast static route.

Command Syntax

set protocols static [vrf <vrf-name>] route <ip-address> next-hop <nexthop-address>

Parameter

Parameter	Description
vrf <vrf-name>	Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. NOTE: When a VRF name is specified, find the next hop routing information from the specified VRF domain. When no VRF is specified, find the next hop routing information from the default VRF.
route <ip-address>	Specifies a destination IPv4 or IPv6 address network segment for route. For example, 192.168.1.0/24, 200::0/64
next-hop <nexthop-address>	Specifies the next-hop address. For example, 10.10.1.0, fc00:0:0:2002::2.

Usage Guidelines

On a simple network, you only need to configure static routes to ensure that the network runs properly. When the destination IP address is set to 0.0.0.0/0 or 0::0/0, a default route is configured. If the switch cannot find a route in the routing table to forward packets, the switch will use the default route to forward packets.

The static route entries are in the default VRF if not explicitly bound to any VRF.

Example

Set the next-hop address of 192.168.1.0/24 to 10.10.0.1.

admin@Xorplus# set protocols static vrf vrf100 route 192.168.1.0/24 next-hop 10.10.0.1
admin@Xorplus# commit