protocols rip interface vif address request-interval

To configure the RIP request interval when the switch has no known neighbors, use the set protocols rip interface vif address request-interval in L2/L3 configuration mode.

Command Syntax

set protocols rip interface interface-name vif vif-name address ip-address request-interval time

Parameters

interface-name	Interface name.
vif-name	Virtual interface name.
ip-address	Virtual interface IP address used for RIP.
time	RIP request interval when there are no known neighbors. The valid range is 1-10,000. Use 0 to disable periodic RIP requests.

Example

This example configures the RIP request interval to 10 seconds, when the switch has no known neighbors:

admin@Switch# set protocols rip interface vlan10 vif vlan10 address 10.1.1.1 request-interval 10