protocols rip interface vif address triggered-delay

To configure the delay before sending repeated triggered updates, use the set protocols rip interface vif address triggered-delay command in L2/L3 configuration mode.

Command Syntax

set protocols rip interface interface-name vif vif-name address ip-address triggered-delay time

Parameters

interface-name	Interface name.
vif-name	Virtual interface name.
ip-address	Virtual interface IP address for RIP.
time	Trigger delay time in seconds. The range is 1-180.

Example

The following example configures 10 seconds as the delay before sending repeated triggered update:

admin@Switch$set protocols rip interface vlan10 vif vlan10 address 10.1.1.1 triggered-delay 10