set protocols snmp trap-group source-interface

The set protocols snmp trap-group source-interface command configures the source interface from which traps are sent.

Command Syntax

set protocols snmp trap-group source-interface <source-interface>

Parameter

Usage Guidelines

You can run this command to specify the source interface on the device from which traps are sent. The specified source interface is used to derive the source IP address for the SNMP traps sent, so that traps received from each switch will always have a single consistent source IP address. To ensure device security, it is recommended that you set the source interface to the loopback interface.

Example

• Configure the loopback interface as the source interface from which traps are sent.

admin@Xorplus# set l3-interface loopback lo address 10.226.14.201 prefix-length 32
admin@Xorplus# set protocols snmp trap-group source-interface lo
admin@Xorplus# commit