set protocols pimsm4 bootstrap cand-rp group-prefix cand-rp-by-vif-addr

The set protocols pimsm4 bootstrap cand-rp group-prefix cand-rp-by-vif-addr command configures the IP address of a VLAN interface or loopback interface to use as the C-RP in the multicast group.

Command Syntax

set protocols pimsm4 bootstrap cand-rp group-prefix <IPv4Net> cand-rp-by-vif-addr <IP-address>

Parameter

Parameter

Description

group-prefix <IPv4Net>

Specifies the range of multicast group that can serve on a C-RP. The value is an IPv4 multicast subnet address in the address/prefix-length format, e.g., 239.0.0.0/8.

cand-rp-by-vif-addr <IP-address>

Specifies the IP address of a VLAN interface or loopback interface to use as the C-RP.

NOTE:

To avoid frequent protocol changes caused by interface flapping, using loopback interfaces is recommended.

Example

Configure the IP address of a VLAN interface or loopback interface to use as the C-RP in a multicast group to 2.2.2.2.

admin@Xorplus# set protocols pimsm4 bootstrap cand-rp group-prefix 239.0.0.0/8 cand-rp-by-vif-addr 2.2.2.2
admin@Xorplus# commit