set protocols ospf4 area interface vif address passive host

To make OSPF advertise host route, use the set protocols ospf4 area interface vif address passive host in L2/L3 configuration mode.

Command Syntax

set protocols ospf4 vrf vrf-name area area-id interface interface-name vif vif-name address ip-address passive host { true | false }

Parameters

vrf-name	Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. Note that: The configuration is in the default VRF if not explicitly bound to any VRF.
area-id	OSPF area identifier. Use dotted decimal notation. For example, use 0.0.0.0 for area 0.
interface-name	Interface name
vif-name	Virtual interface name.
ip-address	Virtual interface IP address.
true	Advertise host route.
false	Do not advertise host route.

Example

The following example makes the OSPF interface advertise host route:

admin@Switch# set protocols ospf4 area 0.0.0.0 interface vlan2 vif vlan2 address 10.2.2.1 passive host true