set protocols ospf4 area interface vif address passive disable

To make an OSPF interface passive, use the set protocols ospf4 area interface vif address passive disable command in L2/L3 configuration mode.

Command Syntax

set protocols ospf4 vrf vrf-name area area-id interface interface-name vif vif-name address ip-address passive disable { true | false }

Parameters

vrf-name	Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. Note that: The configuration is in the default VRF if not explicitly bound to any VRF.
area-id	OSPF area identifier. Use the dotted decimal notation. For example, use 0.0.0.0 for area 0.
interface-name	Interface name.
vif-name	Virtual interface name.
ip-address	Virtual interface IP address.
true	Do not make the OSPF interface passive.
false	Make the OSPF interface passive.

Example

The following example makes the OSPF interface passive:

admin@Switch# set protocols ospf4 area 0.0.0.0 interface vlan2 vif vlan2 address 10.2.2.1 passive disable false